Comments on: Plutohome, Asterisk and a X100P FXO Card

By: Ed Stafford

Ed Stafford — Tue, 13 Nov 2007 20:23:38 +0000

If you are using PlutoHome, I believe the default channel name/ID is “g0″.
You can see this if you log into the AMP portal from your local pluto admin site.

Make sure that your channel setting in zapata.conf also reflects the same identifier “g0″

In my comfig, I actually changed both to just “0″ for the channel (that’s number zero without quotes).

By: Valerian

Valerian — Sun, 11 Nov 2007 20:44:20 +0000

Can you post the details of how you got the rest to work.

I was able to install the drivers and modules. However I cannot seem to see any channels when I type CLI> zap show channels. However when I use CLI> zap show status; I can see my two X101P boards detected.

I have edited /etc/asterisk/zapata.conf with a config that work in another disto … but still no channels.